Five12.net -- Online Forum for the Numerology Music Sequencer

Five12.net -- Online Forum for the Numerology Music Sequencer (http://www.five12.net/index.php)
-   Vector Sequencer : News (http://www.five12.net/forumdisplay.php?f=38)
-   -   Repeat Page bugs? 1.0.7 (http://www.five12.net/showthread.php?t=3657)

blackdoors 02-02-2019 10:27 AM

Repeat Page bugs? 1.0.7
 
Having some intermittent problems on the repeat page, with certain parts.

One one, the 9th encoder can only change 1X to 8X, no other values are accessible.

On another part, Step 4 can only be set from 1X to 8X using encoder 4.

I can't see anything 'special' about these steps and parts, any ideas?

John

jim 02-04-2019 11:24 AM

I don't see anything in the code that obviously limits what you set step repeat to. I'd say send me either a copy of the project or a short video via jim@five12.com. For video, you can send email or iMessage. To send me the project, connect the Vector in disk mode, find the folder for that project, .zip up the whole folder and email that.

Two things I'd want to look at: is it a UI update issue, or is parameter modulation somehow involved...

Cheers,
Jim

blackdoors 02-04-2019 04:17 PM

Hi Jim, thanks for this I will do when back at the machine at the end of the week.

The same project seems to have the preset and scene pages not working at all (unless Iím totally misunderstanding something), so might be something a bit messed up about it somehow.

John

blackdoors 02-09-2019 06:10 AM

Sent you a video with a reproduction - I think the issue occurs very repeatedly in conjunction with using 'select' to choose one or more parts. The selected parts are the ones affected. Doesn't seem to be project specific.

I did think this happened another time without select (project specific), but if I can find that project I will email that one to you as well. In that case, it's possible I was using select without realising.

All the best!
John

cliffman 02-11-2019 07:33 PM

I can confirm this, v1.0.7:
- start with new project
- pick a part
- go to Repeat page
- select a couple of steps
- turn either encoder 9 or individual encoders, Repeats jump to x8 and stick there
- unselect the step and the individual encoder works fine.

jim 02-12-2019 10:31 PM

This will be fixed in the next build. The repeat param is a bit unusual in that it shares a byte w/ the flags for skip, mute & select, and the UI wasn't accepting for that when reading the param -- anyway, an unusual case, all fixed now....

Cheers,
Jim


All times are GMT -6. The time now is 06:55 PM.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.