View Single Post
  #3  
Old 04-30-2017, 07:24 AM
Arboria Auralist Arboria Auralist is offline
Member
 
Join Date: Oct 2013
Location: Brighton, UK.
Posts: 66
Default

My N4 projects are rarely without:

Param-modding signals as the x & y targets of Triple XY modules, using their glide functionality to apply slew to the signal.

Building sequenced logic stuff with the S&H Shift Register, Binary Op modules, sequenced/logic controlled audio & CV Switches, and Gate Sequencers.

Using all of the CV busses and CV In/Out modules to "stealthily" transport control signals between stacks.

Similary, using the Audio Out module (in InputOutput category) for Audio routing beyond each stack's 8 main aux outputs (which can of course be remapped per stack) and tapping aux audio off before each stack's primary output.

Putting a Pan & Volume before each audio Stack's output so I can trim the channel's gain before it reaches the stack's main volume control. This lets me keep as much of the main volume control's range usable for gain tweaks.

Last edited by Arboria Auralist; 04-30-2017 at 12:17 PM.
Reply With Quote