View Single Post
  #1  
Old 12-01-2019, 08:29 PM
jim jim is offline
Administrator
 
Join Date: Nov 2008
Location: Albuquerque, NM
Posts: 4,566
Default Vector Firmware 1.4.0

Hi everyone!

This is the production release of the 1.3.X beta builds. This is a big
release which adds Drum parts, custom chords, and many other
tweaks and updates. There is a description of the new features in
the next post, as well as a full set of release notes from the beta builds.
But also, there is a newly updated manual, which you can download here:

http://45.56.118.96/VectorUserGuideV1.4.pdf

There are 4 completely new pages, two for Chord & Drum Parts,
and one each for the Dashboard and Tips & Tricks. There are also
some updates to the pages for Sequence Controls, Chance Ops and Sub-Sequencers.

Download:

http://45.56.118.96/VS-1.4.0/VECTOR.BIN.zip


Vector Sequencer Firmware Update Instructions

• Download and un-zip the Vector firmware file (VECTOR.BIN.zip).
• Press and hold the Shift button while powering up the Vector to enter USB Disk mode.
• Use a USB ‘A to B’ cable to connect the Vector to your computer. After a few seconds,
the SD Card for the Vector will show up as a new disk.
• Unzip VECTOR.BIN.zip. On a Mac, the Finder may do that for you. Do not double-click on VECTOR.BIN,
which the Finder will try to de-compress into something not useful.
• Make sure the filename is exactly VECTOR.BIN, and copy it to the root directory of Vector’s SD Card – Delete
or move any previous VECTOR.BIN firmware files.
• Now is also a good time to backup your Vector's PROJECT directory.
• Unmount/Eject the Vector’s SD Card from your computer, and power off your eurorack system.
• Hold down the Rec button on the Vector while powering up your system.
• Press Next to load the new Firmware, which takes about 20 seconds.
• Verify the Firmware is the correct version in Globals -- first page, 2nd OLED, top-left corner.

Last edited by jim; 12-04-2019 at 02:50 PM.
Reply With Quote