View Single Post
  #2  
Old 12-08-2016, 06:09 AM
jue's Avatar
jue jue is offline
Numerologist
 
Join Date: Nov 2008
Location: european outback
Posts: 650
Default

Hello,
just try the Scale and Offset module at the end of your chain to calibrate the CV.
If you need to see the values in front and after this module just use two binary op modules were the second value is 1 and the operator is multiplication there you could see whats going in and out. At the Scale and Offset module the first value is multiplicated with the CV signal while the second is added.
hope this helps
jue
__________________
Reply With Quote