Vector Sequencer Firmware 1.2.3

[jim]

This build fixes an issue that could occur when saving projects.

Cheers,
Jim

http://files.five12.com/VS-1.2.3/VECTOR.BIN.zip

Release Notes:

1.2.3:
- Fixed a problem that could cause a blank dialog when saving a file.
- Fixed an issue that could keep the SD card from working properly when saving a file.



Vector Sequencer Firmware Update Instructions

• Download and un-zip the Vector firmware file (VECTOR.BIN.zip).
• Press and hold the Shift button while powering up the Vector to enter USB Disk mode.
• Use a USB ‘A to B’ cable to connect the Vector to your computer. After a few seconds,
the SD Card for the Vector will show up as a new disk.
• Unzip VECTOR.BIN.zip. On a Mac, the Finder may do that for you. Do not double-click on VECTOR.BIN,
which the Finder will try to de-compress into something not useful.
• Make sure the filename is exactly VECTOR.BIN, and copy it to the root directory of Vector’s SD Card – Delete
or move any previous VECTOR.BIN firmware files.
• Now is also a good time to backup your Vector's PROJECT directory.
• Unmount/Eject the Vector’s SD Card from your computer, and power off your eurorack system.
• Hold down the Rec button on the Vector while powering up your system.
• Press Next to load the new Firmware, which takes about 20 seconds.
• Verify the Firmware is the correct version in Globals -- first page, 2nd OLED, top-left corner.